Why is my Klutch Water Filtration Systems leaking oil through the housing and needle assembly?
If oil is leaking through the housing and needle assembly, the O-ring (3.2) is likely damaged. Replace the O-ring to fix the leak.
What to do if there is a continuous leak through the knob of my Klutch Water Filtration Systems?
If you're experiencing a continuous flow or leak through the knob, it could be due to a damaged diaphragm assembly (9) or damaged seating on the valve cone. Try replacing the diaphragm assembly (9) or the valve cone assembly (13). Also, there might be dirt between the seating and the valve cone (13). In this case, clean and reassemble the parts.
How to fix restricted air flow in Klutch Water Filtration Systems?
Restricted air flow can occur if the filter element (5) is clogged. To resolve this, clean the filter element and then replace it.
Why is my Klutch Water Filtration Systems leaking air from the bottom of the metal bowl guard?
Air leaks from the bottom of the metal bowl guard usually indicate that the O-ring (7.2.3) is damaged. Replace the O-ring to fix this issue.
Why is setting pressure slow on my Klutch Water Filtration Systems?
Slow pressure setting can occur if the seat on the valve cone is damaged or if there is dirt between the seating and the valve cone. Replace the valve cone assembly (13) if the seat is damaged. If dirt is present, clean the seating area and reassemble.
What to do if the water level is not visible in Klutch Water Filtration Systems?
If the water level is not visible, it's probably because of dirt on the inner surface of the polycarbonate bowl (7.1.1). You should clean the polycarbonate bowl.
Why is my Klutch Water Filtration Systems leaking air through the sight dome (1)?
If there's an air leak through the sight dome (1), it usually means that the O-ring (1.3) is damaged. Replace the O-ring to stop the leak.
Why is my Klutch Water Filtration Systems leaking air through the oil filling plug (2.1)?
If air is leaking through the oil filling plug (2.1), it's likely that the O-ring (2.2) is damaged. Replace the O-ring to fix this.
What to do if the knob of the drain valve does not return on my Klutch Water Filtration Systems?
If the knob of the drain valve does not return, it's likely that the valve components are stuck. Try pulling the knob and operating it. If the valve gets stuck again, replace the semi-auto drain valve assembly.
Why is my Klutch Water Filtration Systems leaking air from housing (1) and metal bowl guard (7.3)?
Air leaks from the housing (1) and metal bowl guard (7.3) interface are typically due to a damaged O-ring (7.1.2). Replacing the O-ring should resolve this issue.
General| Brand | Klutch |
|---|---|
| Model Number | 48577 |
| Filter Type | Sediment |
| Operating Temperature | 40 - 100° F |
| Inlet/Outlet Size | 1 inch NPT |
To Next Page