(3) Running belt jam - If the running belt is in dead condition, use the Allen key (J) to turn the screw 1/2 a
turn both left and right until the jam solved (see fig3). You can also adjust the tension of the running belt by
turning the both left and right screws with Allen key (J).
1. Regular maintenance will prolong the life of your treadmill and prevent injury.
2. Switch Off and remove the power cable from the wall after every use, especially if children are present.
3. Clear belt and dial plate after use, wipe clean with damp cloth. Do not use abrasive material or
solvents.
4. Check and tighten screws and spines at fixing point.
5. Special pay attention to the belt which is the most susceptible to wear.
6. Do not hang clothes or other objects on the machine.
7. Keep far away from children when not in use.
8. Always store in a flat surface and a dry & ventilated area.
KMART CUSTOMER SERVICE
AU: 1800 124 125 NZ: 0800 945 995
©KMART AUSTRALIA LIMITED
KMART AUSTRALIA – 690 SPRINGVALE ROAD, MULGRAVE, VIC 3170 AUSTRALIA.
KAMRT NEW ZEALAND – REGIONAL OFFICE C/O KMART PAPATOETOE STORE.
HUNTERS PLAZA, GREAT SOUTH ROAD, PAPATOETOE, AUCKLAND, NEW ZEALAND.
Made in China
To Previous Page
Loading...
General