Page: 12/28
stopper.
1. Manual drainage:
V. Drainage Instructions
1）When the machine stops after the water is full, turn off the machine power and unplug the
power plug.
Notes: Please move the machine carefully, so as not to spill the water in the water pan at the
bottom of the body.
2）Place the water container below the side water outlet behind the body.
3）Unscrew the rotary knob and unplug rubber stopper, the water will automatically flow into
the water container.
Notes: 1. Keep the rotary knob and rubber stopper in a safe place for ease of locating.
2. During drainage, the body can be tilted slightly backwards.
3. If the water container cannot hold all the water, before the water container is full,
plug the water outlet with rubber stopper as soon as possible to prevent water from
flowing to the floor or the carpet.
4）When the water is discharged, plug rubber stopper, and tighten the rotary knob.
Notes: 1. Restart the machine after rubber stopper and rotary knob are installed, otherwise
condensate water of the machine will flow to the floor or the carpet.
2. Continuous drainage (only applicable to cooling and dehumidification mode), as shown in
figure: (Drainage Pipe Not Inlcuded)
1） Unscrew the rotary knob and unplug rubber
2） Set the drainage pipe into the water outlet.
3）Connect the drainage pipe to the bucket.
Note: If the internal bucket becomes full, the unit display
will show "FL" and the unit will turn off as a safety
feature.
To Next Page
Loading...
