Di shwa she r m ust be l evel fo r pr oper d ish ra ck op eration a nd w ash perfo rman ce.
Place a spirit level on door and rack track inside the tub as shown to check that the
dishwasher is level.
level the dishwasher by adjusting the three levelling legs individually.
When level the dishwasher, please pay attention not to let the dishwasher tip over.
1
2
3
I ll ustration o f fe et ad justment
ććFigure 5
NOTE:
The maximum adjustment
height of the feet is 50 mm.
This applia nce must b e ear thed. In the ev en t
of a mal function or brea kdown, ear thi ng wil l
reduce the risk of el ectric sho ck by providin g a
path of least resistance for the electric current.
This app li an ce is eq uip ped with a cord having an
equi pment-ea rthing co ndu ctor and an e arthing
plug . T he plug m ust b e plu gged int o an ap propriate
outlet t hat is in st alled a nd ear thed i n ac cordanc e
with all local standa rds a nd requ irement s.
I mprop er connec tion o f th e equ ipm ent -
gro und ing con ducto r ca n re sul t i n th e risk
of an el ectric shock. C he ck wi th a qu alifi ed
electri ci an or serv ice representativ e if you
are i n d oubt whe ther the app li an ce is prop erly
gro und ed. Do n ot mo di fy the plug p rovi ded w ith
theappliance;Ifitisnotfit fortheoutlet.
Havea properoutlet installedbyaqualified
electrician.
Ensure the voltageand frequency of the power being correspondsto
those on the rating plate. Only insert the plug into an electrica lso cket which isea rthed
prop erly. If th e el ec tri cal socket to w hich the appli anc e m ust b e co nnecte d is not
appropriate for the plug , replace the socket, rather th an using a adaptors or the like as
th ey co ul d ca use ov e rhea ting a nd bu rns.
Plea se lo ok at th e ra ting lab el to kno w t he rat ing v olta ge and c onnect the dishwash er to the app ropriate power s upply.
Use the r equi red fuse 10 amp , tim e de lay fuse or c ircu it br eake r r ecommen de d and prov id e sepa rate ci rcuit serv ing
only thi s app liance.
For personal safety:
DO NOT US EAN EXTENSION CORD OR AN ADAPTE R PLUG W ITH THISAPPLIANC E.
DO N OT, UNDERANY C IRCUMS TANCES, CUT OR R EMOVE T HE EARTHING
CONNECTION FROM THE POWER CORD.
Check level si de to s ide
Spirit level
Check l eve l Fron t to Bac k
Pull The safety supply hoses completely out from storage compartment located at rear of dishwasher.
Turn water fully on before starting the dishwasher.
1
Tighter the screws of the safety supply hose to the faucet with thread 3/4inch.
2
3
The appliance must be connected to the water mains using new hose-sets.
The old hose-sets should not be reused.
Water pressure must be between 0,04 MPa and 1 MPa. If the pressure is below theminimum
consult our Service Department for advice.
To Next Page
Loading...