Please c lose t he hydrant after using.
Turn off the water.
Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and
the room, from severe splashing.
Unscrew The safety supply hose from the faucet..
2
1
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the
wa ter is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and
damage the appliance.
A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink has one, it
is recommended thet the hose be disconnected and the hole plugged.
The safety supply hose consists of the double walls. The hose's system guarantees its intervention by blocking the flow of water
in case of the supply hose breaking and when the air space between the supply hose itself and the outer corrugated hose is full
of water.
Positioning theAppliance
How to Drain Excess Water From Hoses
If the sink is 100 0 hi gh er fr om the floor, the exces s w ater i n ho ses cannot b e dr ai ned di re ctly
into the sink. It will benecessary to d rain excess water fro mhoses into a b owl or suitable
conta iner th at is held ou tside and lower than the si nk.
Water Outlet
Connectthe water drain hose. Thedrain hose must becorrectly fitted toav oid waterleaks.
En sure tha t th e wat er i nl et hose is n ot ki nked or s quashed.
The following things should be checked before starting the dishwasher.
Syphon Connection
Insert t he d rain hos e int o a d rain pipe wi th a minimum diamete r o f 40m m, o r let it ru n int o th esin k, m ak ing su re t o
avoid b e n din g or cr im p i ng it. T h e top of t he h ose m u st be l ess t ha n 10 00mm.
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
Extension Hose
If y ou n eed a dr ain h ose ext ension, make sure t o use a simil ar dra in ho se.
It m ust be n o lo nger than 4 m et res; o ther wise the cleanin g e ffect o f t he di shwashe r cou ld b e re duce d.
1 The dishwasher is level and fixed properly
2 The inlet valve is open
3 There is a leakage at the connections of the conducts
4 The wires are tightly connected
5 The power is switched on
6 The inlet and drain hoses are knotted
7 All packing materials and printings should be taken out from the dishwasher
Positi on the appliance in the desired location. T he bac k should rest ag ainst th e wall beh ind i t, an d the sid es,
along the adjacent cabin et s or walls. The dis hwas her i s equipped w ith wat er supply and dr ain h oses th at can
be positioned either to the right or the left sides to facilitate p ro per i nstalla ti on.
To Next Page
Loading...