Witheachwashcycle.
Compartment
For pro grammes with pre-wash onl y.
(Follow the us er instr uctions!)
Electric indic ator on control pane l (if pro vided).
Check the rinse aid level
(On models with wat er softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a programme
Close the door , t urn on the water tap and press the Start/Pause button. The machine will start working
after about 10 seconds.
Runni ng the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few m inutes (about 15 minutes) before unloading the dishwasher to avoid handling
the dishes and utens ils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from the lower b asket.
Changing the programme
Add forgotten dishes in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then l oad the baskets. Refer to the dishwashe r loadin g instructions.
Press the Programme button until the selected programme lights up.
( See the section entitled Oper ationg instruction )āā
When the working cycle has finishe d, the buzzer of the
dishwasher will soun d 8 times, then stop.
Turn off the appliance using the Power button.
If the appliance is switched
off during a wash cycle.
Open the do or carefu lly.
Hot s team may esc ape
when the do or is o pened!
If the appliance is switched off during a wash cycle, when switched
on agai n, please re-select the washing cy cle and operate the dishwasher
according to the original Power-on state ).
Switch on the appliance Press the Power bu tton to switch on the appliance, Open the door.
For detailed operating method read the corresponding content on the instruction manual.
1. A running cycle can o nly be modified if it has been running for a short time. Otherw ise the detergent
m ay have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Pres s the S tart/Pause button, then press the program button for more than 3 seconds to cancel the
running programme.
3. Select a new programme.
4. R estart the dishwash er.
1.Press the Start/Pause Button to stop the washing.
2.Open the door a little .
3.After the spray arms stop working, you can open the doorcompletely.
4.Add forgotten dishes.
5.Close the door
6.Press the Start/Pause Button, the dishwasher will run after 10 seconds.
To Next Page
Loading...