Step 3: Secure Center Frame Hinge
Connect the front (green) and rear (white) frame sections by
closing the center frame hinge. The hinge pin will lock into place
(see left photo). Next, ensure the frame is securely locked into place
by sliding the frame lever into the slot (center photo). Rotate the
lever clockwise to tighten and then press the lever firmly down
until it is locked in place (see left photo).
Step 4: Install Knee Platform and Set Handlebar Height
The knee platform is designed to be used with either the right or left
leg. Insert the knee platform post into the receptacle tube and set the
knee platform at your desired height for use by inserting the locking
pin through the aligned holes. Finally, tighten the clamp lever to secure
the knee platform in place. (see left photo below)
Open the steering height lever, and pull up on the handlebars to set at
the desired height - typically waist height. Next, turn the ribbed knob
clockwise to tighten the clamp and firmly push the steering height
lever to closed and locked position (see bottom right photos).
Setup Continued & Maintenance:
Step 5: Brake Operation
To engage the hand brake, squeeze the brake lever on handle bar.
The KneeRover
®
scooter comes equipped with a brake lock /
parking brake. Simply squeeze brake handle firmly and press the
button to engage the lock. To release the lock, squeeze the brake
handle again.
Ongoing Maintenance
With routine use, nuts and bolts on the steering column and brake
assembly can become loose. To ensure safe operation of this
KneeRover
®
scooter it is important to periodically inspect the knee
walker for loose nuts and bolts and re-tighten as appropriate.
The KneeRover
®
GO is designed to quickly
breakdown for compact portability and easy
transport. To learn how to breakdown the
KneeRover
®
GO, and for additional support in
maintaining your knee scooter, please visit:
kneerover.com/pages/kneerover-maintenance-videos
To Next Page
Loading...
