504G3 SERIES TRACTOR OPERATION MANUAL
6
Do
not attempt to operate the machine if you are feeling unwell. By doing so you
could be a danger to yourself and those you work with.
You can reduce the risk of damage to the machine or your body by following the
instructions in this manual.
If you do not understand any parts of this manual and need assistant, contact your
Knegt dealer.
This machine is manufactured in compliance with legislative and other requirements.
It should not be altered in any way which could affect or invalidate any of these
requirements. For advice consult your Knegt Distributor.
Use only the Knegt approved attachments that are specified for your
machine. Operating with nonspecified attachments can overload the
machine, causing possible damage and machine instability which could result in
injury to yourself or others. The use of non-approved attachments could invalidate
your warranty.
1.1.2Startthetractor
1. Keep all guards and shields in the right place.
2. Make sure that everyone be away from the
machine, attached implements, and work area
before starting engine or operation.
3. Start engine only from seat with shuttle control in
Neutrual.
4. Front drvie lever should be netural and PTO
switch must be disengaged before starting the
engine.
5. Make sure all implements are fully lowered
down to the ground before starting the engine.
6. Don’t start engine by shorting across starter
terminals. Otherwise it may cause injury or even
death to you.
1.1.3Operatingthetractorsafely
1. Select the track width setting best suited for work, always keeping tractor stability
To Next Page
Loading...
