Why can’t the implement on my KNEGT 404G2 reach the highest position?
If the sink speed of the implement is normal, but it can’t reach the top position or exceed the top position on your KNEGT Tractor, it could be because the extension rod is too short or too long; adjust the length.
How to fix oil leaks in KNEGT Tractor?
Oil leaks in your KNEGT Tractor can stem from a few common issues. Check if the bolts at the pipe joints are loose and tighten them. Also, inspect the rubber rings at the pipe joints or crankshaft journal for breakage and replace them if needed. Finally, examine the washers for unevenness or damage and replace them as necessary.
What to do if the brake fails on my KNEGT Tractor?
If the brake fails in your KNEGT Tractor, it could be due to a seriously or eccentrically worn brake disk, or the free path of the brake pedal might be too large. To address this, put air out of the pipe or readjust the free path.
Why is the steering so heavy on my KNEGT 404G2?
If the steering on your KNEGT Tractor feels too heavy, several factors could be responsible. The great pump might be supplying insufficient oil, experiencing an internal leak, or the filter net in the oil case could be blocked; check the pump and clean the filter net. Air in the steering system or oil with foam can also cause this issue; eliminate the air and inspect. Finally, the steering oil case might not be supplying enough oil; replenish the oil to the specified level.
Why is the temperature of the accumulator too high in my KNEGT 404G2 Tractor?
If the temperature of the accumulator in your KNEGT Tractor is too high, it could be because the current is too large; check and adjust it.
Why does the starter motor rotate before the gears engage, causing the gear ends to hit each other on my KNEGT 404G2 Tractor?
If the starter motor rotates before the gears are engaged, causing the gear ends to hit each other on your KNEGT Tractor, it could be because the distance of the copper disk in the motor relay is too small; adjust it.
Why does my KNEGT Tractor steer wander during braking?
If your KNEGT Tractor wanders while steering during braking, it could be because the left and right brake pedals’ free paths are different; adjust them. The brake disk may be damaged on one side, requiring replacement. The air pressures in the two rear tires might also be different; check up and air up the tires as per regulation.
Why are the bearings of the helical bevel pinion and differential shaft in my KNEGT Tractor so hot?
If the bearings of the helical bevel pinion and differential shaft in your KNEGT Tractor are running at a high temperature, it could be due to excessive pre-tension; adjust it. Poor lubrication is another potential cause; check the oil level and replenish if needed.
Why are the front wheels swaying on my KNEGT 404G2 Tractor?
Swaying front wheels on your KNEGT Tractor can be caused by several issues. The bearing of the front driven axle may be heavily abraded, requiring replacement. Similarly, a heavily abraded bearing of the steering knuckle should also be replaced. If the clearance of the front and rear supporting seat is too large, it needs adjustment. A seriously deformed front wheel rim should be corrected. Finally, improper front wheel toe-in adjustment should be adjusted.
Why does the PTO on my KNEGT 404G2 have no power?
If the PTO on your KNEGT Tractor has no power, it could be due to the driven plate lining in the hydraulic clutch being heavily abraded or the abrasion leaning to one side, requiring replacement. Another potential issue is a broken valve, which would also need replacing. Lastly, heavy leakage in the hydraulic clutch could be the cause, necessitating its replacement.
To Next Page
General
