Why can't I put down the implement on my KNEGT 404G2?
If you cannot put down the implement on your KNEGT Tractor, it could be due to the main control valve or the sink valve being blocked; clean them. The sink speed control valve might be screwed too much; loosen it. The rapid lift lever could also be flexural; adjust the rapid lift lever backwards.
Why isn't the generator charging enough or charging unsteadily on my KNEGT 404G2 Tractor?
If the generator in your KNEGT Tractor does not charge enough or charges unsteadily, it could be due to a loose transmission V belt, causing the generator rate to decline; adjust it. The point of the wire might be loose; fasten the bolt. The carbon could be broken; check and repair it. The regulator might be damaged; check and repair it.
Why is there a noise in the generator of my KNEGT Tractor?
If there is a noise in the generator of your KNEGT Tractor, it could be because the generator is installed incorrectly; reinstall it. The bearing of the generator might be broken; replace it. The rotor might be meeting with the stator or something else; repair it.
Why doesn’t the starter motor work on my KNEGT 404G2 Tractor?
If the starter motor does not work on your KNEGT Tractor, it could be because the wire is broken or the wire joint doesn’t connect correctly; weld or replace the wire, clean the dirt, and fasten the bolt. The fuse might be broken; replace it. The battery volume could be insufficient; charge the battery.
Why does the starter motor start weakly and fail to start the engine on my KNEGT 404G2?
If the starter motor starts weakly and cannot start the engine on your KNEGT Tractor, it could be because the bearing is abraded seriously and the pivot touches the housing; replace the bearing. The carbon brush and the collector might contact poorly; adjust them. The commutator surface may be burnt or stained with oil; clean the oil and grind by “0” model non metal sand paper. The wire might connect unwell; fasten the joint. The main touch point of the electromagnetic switch could be burnt out and have poor contact; grind by “0” model non metal sand paper. The battery volume might be insufficient; recharge it.
Why does the starter motor continue to rotate after the engine has started on my KNEGT Tractor?
If the starter motor continues to rotate after the engine has started on your KNEGT Tractor, the copper disk in the motor relay may keep linking with two touch points; check and repair it. The distance of the copper disk in the motor relay might be improper; adjust it.
Why does the starter motor rotate before the gears engage, causing the gear ends to hit each other on my KNEGT 404G2 Tractor?
If the starter motor rotates before the gears are engaged, causing the gear ends to hit each other on your KNEGT Tractor, it could be because the distance of the copper disk in the motor relay is too small; adjust it.
Why does the PTO on my KNEGT 404G2 have no power?
If the PTO on your KNEGT Tractor has no power, it could be due to the driven plate lining in the hydraulic clutch being heavily abraded or the abrasion leaning to one side, requiring replacement. Another potential issue is a broken valve, which would also need replacing. Lastly, heavy leakage in the hydraulic clutch could be the cause, necessitating its replacement.
How to fix oil leaks in KNEGT Tractor?
Oil leaks in your KNEGT Tractor can stem from a few common issues. Check if the bolts at the pipe joints are loose and tighten them. Also, inspect the rubber rings at the pipe joints or crankshaft journal for breakage and replace them if needed. Finally, examine the washers for unevenness or damage and replace them as necessary.
What to do if the brake fails on my KNEGT Tractor?
If the brake fails in your KNEGT Tractor, it could be due to a seriously or eccentrically worn brake disk, or the free path of the brake pedal might be too large. To address this, put air out of the pipe or readjust the free path.
To Next Page
General
