KNEGT 404G2 Series - Driving the Tractor

404G2 SERIES TRACTOR OPERATION MANUAL
36
4.2 Driving the Tractor
4.2.1Gettingon andle av in g thetractor
Getting on or leaving the tractor must only be
made where steps（A） and handrails（B） are
provided. Always face the machine when
entering and leaving. Make sure the step(s),
handrails and your boot soles are clean and dry.
Do not jump from the machine. Do not use the
machine controls as handholds, use the
handrails.
Make sure the machine is stopped and correctly parked before entering or leaving
the cab or tractor.
4.2.2AdjustSeatandSteeringWheel
Do not adjust the seat and steering wheel when the machine is in operation.
The operator's seat can be adjusted for your comfort. A correctly adjusted seat will
reduce operator fatigue. Position the seat so that you can comfortably reach the
machine controls. For driving the machine, adjust the seat so that you can depress the
pedals fully with your back against the seat back.
• Use operator’s set
The operator's seat can be adjusted for your comfort. A correctly adjusted seat will
reduce operator fatigue. Position the seat so that you can comfortably reach the
machine controls. For driving the machine, adjust
the seat so that you can depress the pedals fully
with your back against the seat back.
1.Fore/Aft Adjustment
a)Lift handle A upwards and slide the seat forwards
or backwards to the required position.
b)Release handle A and make sure the seat locks
into position.
Fig.4-8
Fig.4-8