KNEGT 404G2 Series - Using the Tractor Implents

404G2 SERIES TRACTOR OPERATION MANUAL
47
4.3 Using the Tractor implents
4.3.1Hydraulicliftsystemcontrolleve r
4.3.1The hydraulic lift system manipulate
These series tractors are half division type hydraulic lift systems; it is the distributor, the
hydraulic oil cylinder parts, such as composition of lifter assembly (see fig. 4-), and to
separate hydraulic pump installation, through the connection line, forming a complete
system.
• Rise and fall farm implements
As shown, push the control forward, the farm implement fall. When the falling block hit
linkage pin, control handle will be back to the neutral position, the farm implement will
stop falling. So you can make the farm implement down to the depth of the need for
agricultural operations by fix the falling block at a specific location.
In a similar way, if you need raise the farm implement, you need to pull the control
handle backward. When the rising block hit linkage pin, control handle will be back to
the neutral position, the farm implement will stop rising. Namely the rising block is
fixed at different locations; you can get different rising height.
In the process of work, if you want to temporarily adjust the depth, you can control
A
C
B
Fig.4-13
Fig. 4-15
A——Front jacking point
B——Middle jacking point of Axles
C——Rear jacking point