404G2 SERIES TRACTOR OPERATION MANUAL
48
the handle rise or fall, after you get the desired depth, you need to move the handle to
the neutral position immediately.
If you need adjust the rising and falling speed, you can rotate the hydraulic lock hand
wheel.
• Farm implement with wheel
--When the tractor working with farm implements which have wheel, the control handle
need to be pushed to the down position, then the distributor automatic back oil, the farm
implements work depth adjusted by wheel.
4.3.2.Usehyd raulicoutputsystem
These series tractors are equipped with two sets of standard hydraulic output circuit, the
option of a set of hydraulic output circuits or simple hydraulic output circuit. It is
located in the rear of the driving seat, when you need hydraulic output, you can control
the joystick of the multiple directional control valve which is located in the driver’s seat
left. Each joystick controls a set of hydraulic output (one in one out). When you use it,
you need put the suspension mechanism in the bottom position and decrease the speed
Fig.4-16
1. Hydraulic
out-le(Optional)
2. Lift arm
3.
Falling block
4. Linkage oin
5.
Rising block
6.
Three-point linkage
lifting control
7.
Hydraulic lock hand
wheel
To Next Page
Loading...
