Why does the gear keep disconnecting itself on my KNEGT 404G2?
If the gear disconnects itself on your KNEGT Tractor, it could be due to a poking fork positioning slot worn seriously; adjust or replace the poking fork shaft. Another reason might be insufficient interlock pin spring pressure; adjust or replace the spring. Finally, worn splines of the teeth seat should be addressed by replacing the teeth seat.
Why can’t the PTO be completely separated on my KNEGT Tractor?
If the PTO on your KNEGT Tractor can’t be separated completely, the button might be broken, so check the button. The driven plate lining in the hydraulic clutch might have been locked up, requiring a check and repair. Alternatively, the return spring of the hydraulic clutch could be broken, necessitating replacement.
What can I do about the front tires wearing quickly on my KNEGT 404G2?
Rapid wear on the front tires of your KNEGT Tractor can be attributed to several factors. Improper front wheel toe-in adjustment should be adjusted. Incorrect front tire pressure should be corrected by charging the tires correctly. Finally, ensure the tread pattern is not mistaken and reinstall if necessary.
Why is there vibration and noise in the clutch of my KNEGT Tractor?
If you're experiencing vibration and noise in the clutch of your KNEGT Tractor, it could be due to the releasing bearing lacking oil or being broken; oiling or replacing it may resolve the issue. Alternatively, the spline of the driven disk or the clutch may have been worn out, requiring replacement.
To Next Page
General
