place. Polarity does not matter.
4. Remove the existing doorbell from the wall and disconnect the wires. Secure the wires so that they can be
connected in a later step.
5. If using an optional wedge, thread the wires at the doorbell through the center of the wedge and mount the wedge
to the surface with the provided screws/anchors.
https://answers.alarm.com/Partner/Installation_and_Troubleshooting/Video_Devices/Alarm.com_Video_Doorbell_(ADC-VDB7…
Updated: Thu, 08 Jun 2023 16:11:26 GMT
4
To Next Page
Loading...