EasyManuals Logo

Knox 7000 User Manual

Knox 7000
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
IMPORTANT WARNING STATEMENTS
WARNING!
This CO alarm is approved for use in single-family residences. It is
NOT designed for marine or RV use. This carbon monoxide alarm
is designed to detect carbon monoxide gas from ANY source of
combustion. This CO alarm is not designed to detect smoke, fire,
or any other gas. It will only indicate the presence of carbon
monoxide gas at the sensor. Carbon monoxide gas may be present
in other areas. The installation of this alarm is not a substitute for
proper installation, use, and maintenance of fuel-burning
appliances, including ventilation and exhaust systems. It does not
prevent CO from occurring, nor can it solve an existing CO
problem.
This carbon monoxide alarm will not sense smoke, fire, or any
poisonous gas other than carbon monoxide even though carbon
monoxide can be generated by fire. For this reason, you must
install smoke alarms to provide early warning of fire and to protect
you and your family from fire and its related hazards.
Audible and Visual notifications from this alarm alert you to
essential directions or potentially dangerous situations. Please be
aware and take note of these notifications. See “ALARM
NOTIFICATIONS” to better understand this alarm. Failure to
respond can result in injury or death.
This CO alarm will not operate without battery power. It will not
operate until the battery has been activated – see “HOW TO
INSTALL YOUR CO ALARM” for activation instructions. The
reset/silence features of this alarm are designed for your
convenience and provide you with time to correct a potential
issue. They will not correct a problem. See "USING THE RESET
FEATURES" for details.
Always check your home for a potential problem after any alarm.
Failure to do so can result in injury or death. Test this CO alarm
once a week. If the alarm ever fails to test correctly, have it
replaced immediately! If the alarm is not working properly, it
cannot alert you to a problem. See “TESTING AND MAINTE-
NANCE” for more information. This product is intended for use in
ordinary indoor locations of family living units. It is not designed
to measure CO levels in compliance with Occupational Safety and
Health Administration (OSHA) commercial or industrial standards.
Individuals with medical conditions that may make them more
sensitive to carbon monoxide may consider using warning devices
which provide audible and visual signals for carbon monoxide
concentrations under 30 ppm.
19

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Knox 7000 and is the answer not in the manual?

Knox 7000 Specifications

General IconGeneral
BrandKnox
Model7000
CategorySecurity System
LanguageEnglish