Need help?Do you have a question about the Ko Propo Esprit-3 Universe and is the answer not in the manual?
General| Brand | Ko Propo |
|---|---|
| Model | Esprit-3 Universe |
| Category | Remote Control |
| Language | English |
Lists essential safety rules for operating the model during use.
Covers selecting model memories and basic trim adjustments.
Details various settings for throttle speed, punch, curve, brake, and acceleration.
Details various settings for steering speed, punch, curve, balance, and travel.
Explains how to change RF modules and crystals for frequency band adjustments.
Step-by-step guide on registering functions into custom menus.
Explains the purpose of DSC and the need for a DSC cable.
Provides instructions on connecting and using the DSC feature.
Essential steps for formatting the Data Pack before its first use.
Explains how Subtrim corrects servo neutral positions.
Provides a step-by-step guide for setting up servos using Trim and Subtrim.
Explains how to add functions to CUSTOM1 and CUSTOM2 menus.
Step-by-step guide for formatting the Data Pack.
Guides on choosing and activating different model memory settings.
Details the procedure for centering servos using Subtrim.
Explains how to activate A.B.S. and adjust its five parameters.
Explains how width and position affect A.B.S. operation.
Explains how throttle speed adjusts throttle reaction rate.
Details how to configure MODE, SPEED, and POSITION for throttle control.
Explains how to make the throttle's initial reaction quicker or slower.
Details how to apply exponential curves to throttle and brake actions.
Explains how to adjust the operating range and quantity of the brake side.
Covers setting the maximum throttle advancement side value.
Allows setting specific throttle positions using ET levers or BT buttons.
Explains how to create a throttle swing effect for better cornering.
Explains how to slow down steering servo speed.
Details configuring speed and position settings for steering.
Explains how to make the initial steering movement quicker.
Details how to apply exponential curves to steering servo movement.
Guides on independently adjusting the left and right steering endpoints.
Explains how to adjust the total range of steering servo movement.
Details how to set the starting throttle position for engine/car startup.
Details how to reverse the direction of servos and ESCs for each channel.
Guides on assigning various functions to ET levers and BT buttons.
Explains how to set a neutral throttle position for easier engine starting or preventing stalls.
Allows setting steering servo movement for three different phases.
Details how to mix brake action from throttle (CH2) to front brakes (CH3).
Details the ULTRA response mode and its requirements.
Provides a diagram and critical warnings for connecting the receiver.
Advises on placement to avoid noise from motors, ESCs, and wiring.
To Next Page
