Kobalt 215908 Operator manual User Manual

Digital Operator Manual
Manuel de I'op_rateur num_rique
Manual del Operador Digital
_E,_ __ Oilless, Single Stage, Direct Drive, Electric Air Compressors
_F,_,_,_, Sans I'huile, d'une seul 6tape, _ prise directe, compresseurs d'air 61ectriques
aciete, de una sola etapa, de mando directo, compresores de aire electricos
4
__E_g/;sh _kWARNING: Read and understand all safety precautions in this manual before operating. Failure to comply
with instructions in this manual could result in personal injury, property damage, and/or voiding of your warranty.
The manufacturer WILL NOT be liable for any damage because of failure to follow these instructions.
_Fte_ch AVERTISSEMENT : Lisez et veillez & bien comprendre toutes les consignes de s6curite de ce manuel avant
A
d'utiliser I'appareil. Toute derogation aux instructions contenues dans ce manuel peut entraP'her I'annulation de la
garantie, causer des blessures et/ou des d6g&ts materiels. Le fabricant NE SAURA 6tre tenu responsable de
dommages resultant de I'inobservation de ces instructions.
|Jms_,,:,h ,_ ADVERTENClA:Leaycomprendatodaslasprecaucionesdeseguridadcontenidasenestemanualantesde
utilizar esta unidad. Si no cumple con las instrucciones de este manual podria ocasionar lesiones personales, dar_os a
la propiedad y/o la anulaci6n de su garantia. El fabricante NO SER,g. responsable de ningQn daSo por no acatar estas
instrucciones.
Printed in U.S.A. 200-2449_ Rev A_3-05

Kobalt 215908 Operator manual Specifications

General

Model Number	215908
Type	Portable
Power Source	Electric
Voltage	120V
Max Pressure	150 PSI

Summary

Safety Guidelines

General Hazards and Risks

Details potential hazards like fire, explosion, shock, burns, and breathing risks associated with compressor operation.

Operational Safety Precautions

Assembly and Installation

Assembling the Compressor

Compressor Controls

Digital Control Panel Operation

Electrical Setup

Electrical Wiring and Circuit Requirements

Grounding Safety Instructions

Pump Break-In Procedure

Initial Break-In Process

Steps for running the compressor for 15 minutes to break in internal parts, including notes on initial electrical smell.

Operating the Air Compressor

Daily Startup Procedure

Steps for starting the compressor daily, including safety warnings, pressure adjustments, and accessory connection.

Shutdown and Storage Procedure

Steps for safely shutting down the compressor, unplugging it, and preparing it for storage.

Maintenance and Care

Draining the Tank

Relief Valve and Leak Testing

Troubleshooting Common Issues

Problem/Solution Guide

Table listing common compressor problems like low pressure, motor issues, and circuit trips with their causes and recommended solutions.