22
CARE AND MAINTENANCE
NOTICE: This is a good time to inspect the drive
sprocket for excessive wear or damage.
Assembling the New Bar and Chain
a. Remove the battery, allow the saw to cool, then
tighten the oil tank cap.
b. Lay the new saw chain in a loop on a flat
surface and straighten any kinks. The cutters
should face in the direction of chain rotation, if
they face backwards, turn the loop over
(Fig. 11b & 11c).
c. Place the chain-drive links into the guide-bar
groove. Position the chain so there is a loop at
the back of the guide bar (Fig. 11d).
d. Place the loop around the sprocket of the
power head.
11c
11d
Bar groove
Chain drive
links
11b
Cutters
Chain drive links
Chain rotation
To Next Page
Loading...
Need help?
General
