Kobalt KM1940-07 - User Manual

Questions and Answers

S
Steven StevensAug 1, 2025
Why won't my Kobalt Lawn Mower start?
- L
  Lauren JenkinsAug 1, 2025
  If your Kobalt Lawn Mower doesn't start, several factors could be at play. First, ensure the battery is fully charged. If that's not the issue, check that the battery is correctly inserted until it clicks into place. Also, grass jammed at the blade can prevent starting; remove the battery and inspect under the deck for any obstructions. If these steps don't resolve the problem, the switch may be defective and require replacement. If the battery still won’t allow the mower to start, you may need to call 1-888-356-2258 for further assistance.
K
Katherine ChambersAug 5, 2025
What to do if my Kobalt KM1940-07 turns off during mowing?
- J
  Joel ElliottAug 5, 2025
  If your Kobalt Lawn Mower turns off during mowing, the battery may need to be charged. Alternatively, grass or debris might be jammed between the blade and deck, so remove the battery and check under the deck for any obstructions. It's also possible that the cutting height is set too low; try increasing it.
K
Kayla Price DDSAug 11, 2025
Why is my Kobalt KM1940-07 so hard to push?
- V
  vazquezerinAug 11, 2025
  If your Kobalt Lawn Mower is hard to push, it might be because the grass is too tall, or the cutting height is too low. Try raising the cutting height. Also, the rear of the mower housing and the blade might be dragging in thick grass. Emptying the grass clippings from the grass catcher bag may resolve this.
R
Ryan MillerAug 16, 2025
How to fix uneven cutting with Kobalt KM1940-07?
- C
  Christina ReyesAug 16, 2025
  If your Kobalt Lawn Mower cuts the grass unevenly, the lawn itself may be rough or uneven, so check the mowing area. It's also possible that the cutting height is not set properly; try moving the wheels to a higher setting.
D
davidcrawfordAug 21, 2025
What to do if Kobalt Lawn Mower does not mulch properly?
- M
  mark04Aug 21, 2025
  If your Kobalt Lawn Mower does not mulch properly, wet grass clippings might be sticking to the underside of the deck. Wait until the grass dries before mowing. Also, make sure the mulching plug is installed.
M
Michael DavilaAug 26, 2025
Why does my Kobalt KM1940-07 vibrate at higher speed?
- D
  Danielle ArnoldAug 26, 2025
  If your Kobalt Lawn Mower vibrates at higher speed, the motor shaft might be bent. Stop the motor, disconnect the mower from the power source, and inspect it for damage. Repair the mower before restarting. The blade may also be unbalanced; in this case, call 1-888-356-2258.