10
kobalttools.com
12. Replace washer lter into garden hose
adapter (K) and attach garden hose to the blue
collar of garden hose adapter (K).
You have now completed assembly and are ready
to begin using your electric power washer. Read
and observe all safety instructions.
OPERATING INSTRUCTIONS
• Turn on water supply at the faucet.
• Make sure the “ON/OFF” switch is in the “OFF” position.
The power switch has international symbols for ‘on’ and
‘off’: On (|) Off (O).
• Unwind the power cord completely and plug into a
grounded 120 volt outlet.
• Release safety push trigger lock up and back into trigger.
While pointing the spray gun in a safe direction, squeeze
the trigger on the spray gun until there is a steady stream
of water, letting the water and air out of the hose. Push
trigger lock back down to lock back into place.
• Turn the power switch to the ‘ON’ (|) position. The unit
will turn on for 1 - 2 seconds and shut off. This is a
normal function of the auto start feature. Squeeze the
spray gun trigger to begin pressure washing.
• Squeezing rapidly will cause the auto start feature to
miss an on/off cycle that may prevent it from turning on
while squeezing trigger after rapid squeezing. Use slow
deliberate trigger pulls to avoid such symptoms.
OFF/0
ON/I
OFF/0
ON/I
2
12
1
K
ASSEMBLY INSTRUCTIONS
To Next Page
Loading...
Need help?
General
