17
OPERATING INSTRUCTIONS
In the AUTO position, the compressor pumps air into
the tank. When a shut-off (preset “cut-out”) pressure is
reached, the compressor automatically shuts off.
If the compressor is left in the AUTO position and air is
depleted from the tank by use of a tire chuck, tool, etc.,
the compressor will restart automatically at its preset
“cut-in” pressure. When a tool is being used continuously,
the compressor will cycle on and off automatically.
In the OFF position, the compressor will not operate.
NOTICE
Unit Care and Maintenance. Drain liquid from
tank daily.
ON/OFF CYCLING OF COMPRESSOR
WARNING
Risk of Bursting. Drain tank every day to
prevent corrosion and possible injury due to
tank damage. For optimal performance of tank
drain, tank pressure should be between 10 -
40 PSI. Do not operate drain with more than
40 PSI in tank or drain valve may be damaged.
Drain tank of moisture daily using the drain
valve in the bottom of the tank.
kobalttools.com
CARE AND MAINTENANCE
WARNING
Risk of Explosion. Disconnect,
tag and lock out power source,
then release all pressure from the
system before attempting to install,
service, relocate or perform any
maintenance.
All repairs should be performed by an authorized service representative.
For efficient operation, perform the following maintenance.
NOTICE
Unit Care and Maintenance. Drain liquid from
tank daily.
To Next Page
Loading...
Need help?
General
