koban KTFD-01 - Cooling System Operation; Sleep Operation

EN KTFD-01
DIGITAL FANCOIL THERMOSTAT
29 / 34
ture in Heating. Fan will run in Medium speed. If room temperature is 0
o
C – 2
o
C higher than setting
temperature in cooling or 0
o
C – 2
o
C lower than setting temperature in Heating. Fan will run in Low
speed.
7.2 Heat system operation
1. Press system switch to heat mode ( ).
2. Press “▲” to adjust the thermostat setting above the room temperature. The heating system should
start to operate.
3. Press “▼“ to adjust the thermostat setting below the room temperature. The heating system should
stop operating.
7.3 Cooling system operation
4. Press system switch to cool mode ( ).
5. Press “▼“ to adjust thermostat setting below room temperature. The cooling system should start to
operate.
6. Press “▲” to adjust temperature setting above room temperature. The cooling system should stop
operating.
7.4 Sleep operation
Push sleep operation button④, appears indicate during the following 8 hours, the thermostat will con-
trol heating or cooling according to following curve. Push sleep operation button again, disappears
indicate the sleep operation feature is cancelled.