Kodak 305 - Installing the Print Paper; Paper Flange Attachment and Power Up; Printer Door Access and Safety

10
OTHERSPRECAUTIONS FEATURES PREPARATION
TROUBLE-
SHOOTING
CONTENTS
PRINT PAPER INSTALLATION
 Attachthesuppliedpaperangestobothsidesoftheprint
paper.
When you pinch the latches on the paper ange, the stoppers retract into the shaft.
Attach the anges to the print paper with the stoppers retracted.
Make sure that the anges are attached to the print paper securely, and release the
latches.
NOTE
• Take care not to pinch your ngers.
• Do not remove the sticker on the print paper roll yet.
• Do not loosen the paper roll. Any slack in the print paper may degrade the print
quality.
CAUTION
• When placing the print paper, keep the print paper upright.
• When you put the print paper sideways, it may roll and fall. This may cause injury.
NOTE
• Fingerprints or dust on the paper’s surface may degrade print quality and cause
paper jams.
Press the POWER switch on the rear panel to turn on the
power.
After the POWER indicator’s color has changed from orange to
green, press the OPEN button to release the printing unit out.
Remove the trim tray and then pull the knob to open the door.
Sticker
INCORRECT CORRECT
BEFORE OPERATION
POWER switch
Knob
OPEN button