Doing more with your camera
www.kodak.com/go/support 15
Adjust the LCD to improve viewability
Let the camera automatically adjust LCD brightness
Leave the LCD Brightness setting at Automatic. (See page 18.)
The LCD automatically adjusts to changing light conditions.
Conserve battery power
1 Press the Settings button .
2 Press to choose LCD Brightness & Glare Shield. Press OK.
3 Press OK to uncheck Automatic.
4 Press to highlight LCD Brightness, then to change the
setting to Low.
5 Press to choose Done, then press OK.
The LCD stays relatively dim to save power.
Manually control LCD brightness
1 Press the Settings button .
2 Press to choose LCD Brightness & Glare Shield. Press OK.
3 Press OK to uncheck Automatic.
4 Press to highlight Enable Glare Shield. Press OK to check it.
5 Press to choose Done, then press OK.
6 Press to return to liveview.
7 In Liveview, press to turn on Glare Shield.
Glare is reduced viewability improved. Videos/pictures are not affected
urg_01216.book Page 15 Friday, March 18, 2011 12:37 PM
To Next Page
Loading...
Need help?
General
