Page | 20
Getting Started
1. The Baby Unit is pre-registered to your Parent Unit.
You do not need to register it again unless the Baby
Unit loses its link with the Parent Unit. If you would
like to add an additional camera, please refer to
section 4.2.1.
2. To re-register your Baby Unit, or register a new
Baby Unit, follow the procedure below:
a. Press “ ” on the Parent Unit for the menu bar.
b. Press “ ” or “ ” button to select , then
“ ” to proceed to the next step.
c. Press “ ” to add camera, then “ ” to
proceed.
d. Press the “ ” button or “ ” button to select
the available camera number. Press “ ” to
add a camera unit.
e. You will then see a sign “ ” to indicate you to
press and hold the pair button of the baby unit
until the irst beep then release the pair button.
2.3 Registration (Pairing)
NOTE: If a particular Baby Unit was registered
previously, registering this current Baby Unit again will
overwrite the old registration.
The Parent Unit will auto detect and pair to the
Baby Unit. Parent Unit will then display live stream
upon successful pairing.
To Next Page
Loading...
