Safety and Related Information
June 7, 2007 2G0734 11
Guidance and Manufacturerís Declaration for Electromagnetic Immunity
The Kodak DryView 5800 Laser Imager is intended for use in the electromagnetic environment specified
below. The customer or user of the Laser Imager should ensure that it is used in such an environment.
Immunity Test IEC 60601 Test
Level
Compliance Level Electromagnetic Environment -
Guidance
Electrostatic dis-
charge (ESD):
• EN61000-4-2
• IEC 61000-4-2
± 6 kV contact
± 8 kV air
± 6 kV contact
± 8 kV air
Floors should be wood, concrete,
or ceramic tile. If floors are cov-
ered with synthetic material, the
relative humidity should be at
least 30%.
Electrical fast tran-
sient/burst:
• EN61000-4-4
• IEC 61000-4-4
± 2 kV for power
supply lines
± 1 kV for input/out-
put lines
± 2 kV for power sup-
ply lines
± 1 kV for input/output
lines
Mains power quality should be
that of a typical commercial or
hospital environment.
Surge:
• EN61000-4-5
• IEC 61000-4-5
± 1 kV differential
mode
± 2 kV common
mode
± 1 kV differential
mode
± 2 kV common mode
Mains power quality should be
that of a typical commercial or
hospital environment.
Voltage dips, short
interruptions and
voltage variations
on power supply
lines:
• EN61000-4-11
• IEC 61000-4-11
<5% Ut* (>95% dip
in Ut*) for 0.5 cycle
40% Ut* (60% dip in
Ut*) for 5 cycles
70% Ut* (30% dip in
Ut*) for 25 cycles
<5% Ut* (>95% dip
in Ut*) for 5 sec.
<5% Ut* (>95% dip in
Ut*) for 0.5 cycle
40% Ut* (60% dip in
Ut*) for 5 cycles
70% Ut* (30% dip in
Ut*) for 25 cycles
<5% Ut* (>95% dip in
Ut*) for 5 sec.
Mains power quality should be
that of a typical commercial or
hospital environment. If the user
of the Kodak DryView 5800 Laser
Imager requires continued opera-
tion during power mains interrup-
tions, it is recommended that the
Kodak DryView 5800 Laser
Imager be powered from an unin-
terruptible power supply or a bat-
tery.
Power frequency
(50/60 Hz) mag-
netic field:
• EN61000-4-8
• IEC 61000-4-8
3 A/m 3 A/m Mains power quality should be
that of a typical commercial or
hospital environment.
NOTE: * Ut is the a.c. mains voltage prior to application of the test level.
To Next Page
Loading...
