42 www.kodak.com/go/support
Getting help
Direct printing (PICTBRIDGE enabled Printer) problems
Picture is too dark ■ Reposition the camera for more available light.
■ Use Fill flash (see page 7) or change your position so light is not
behind the subject.
■ Move so that the distance between you and the subject is within the
effective flash range. (See Specifications starting on page 44.)
■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
Picture is too light ■ Reposition the camera to reduce the amount of available light.
■ Turn the flash off (see page 7).
■ Move so that the distance between you and the subject is within the
effective flash range. (See Specifications starting on page 44.)
■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■ In Smart Capture mode, adjust the Exposure Compensation (see
page 31).
Status Solution
Cannot print to a
PICTBRIDGE Printer
■ In the Setup menu, change the Computer Connection setting to
Other Application (see page 35).
Status Solution
To Next Page
Loading...
