Kodak EKTASOUND 235 - Kodak Ektasound Projector Case; Closing Procedure

KODAK EKTASOUND Projector Case
To close the case,
be^ sure that -
1.
Power cord is removed from Projector
and stored in storage compartment.
2.
Takeup reel is removed From Projector
and placed on reel retainer in case to
prevent scratching the
dust cover.
3.
The holding tabs for the lamp and
the microphone are extended across
the openings.
4.
The elevation wheel on the projector
is fully retracted.
5.
Small objects aren't placed in the
opening for the microphone cord be
-
cause they might slip down into the
case and
be difficult to retrieve
easily.
J~ ..j([(:;<::?= :[{(:;:;. . x. , .: MOVIE
- -
0. *. . :. .. -...
A .:.::<::$[::. .
.:+.::: . . '. .:::'::
.:::;[:[:[($.:: a.
.:==':. . :;[([:.--: "
\
CORD MICROPHONE LAMP
1 NOTE: Equipment shown not supplied with case. STORAGE
KODAK and EXTASOUND are trademarks.