44 www.kodak.com/go/support
Troubleshooting
Picture quality problems
Status Solution
Picture is not clear ■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■ Clean the lens (see page 49).
■ Make sure the camera is not in Macro mode if you are more than
27.6 in. (70 cm) from your subject (see page 33).
■ Place the camera on a flat, steady surface or use a tripod (especially
in high-zoom settings or in low light).
■ Use a larger picture size (see page 31).
■ If you’re manually adjusting the ISO speed, realize that high ISO
setting may cause grainy pictures (see page 32).
Picture is too dark ■ Reposition the camera for more available light.
■ Use Fill flash (see page 10) or change your position so light is not
behind the subject.
■ Move so that the distance between you and the subject is within the
effective flash range. (See Camera specifications, page 47.)
■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■ In Program mode, adjust the Exposure Compensation (see page 32).
Picture is too light ■ Reposition the camera to reduce the amount of available light.
■ Turn the flash off (see page 10).
■ Move so that the distance between you and the subject is within the
effective flash range. (See Camera specifications, page 47.)
■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■ In Program mode, adjust the Exposure Compensation (see page 32).
To Next Page
Loading...
Need help?
General
