Kodak Picture Frame - Still Picture Mode; Slide Show Mode

4
13
Still Picture Mode
To display a single picture, put your Smart Picture Frame in Still Picture Mode.
1 Press the Menu button.
2 Select Slide Show. Press OK.
3 Use the arrow buttons to select Pause Show. Press OK.
4 Use the arrow buttons to select Accept Setting. Press OK.
The picture on the frame is displayed until you:
m Change the Slide Show settings.
m Use the arrow buttons to move to a different picture.
Slide Show Mode
In Slide Show Mode, the Smart Picture Frame continually cycles through all of
the pictures in the frame. If a COMPACTFLASH Card is inserted, pictures on the
card are displayed after pictures in the frame memory.
1 Press the Menu button.
2 Select Slide Show. Press OK.
3 Use the arrow buttons to select the time you would like each picture to
remain on the screen. Press OK.
4 Select Accept Setting. Press OK.
The slide show runs as programmed until you change the settings. The
slide show setting does not apply to pictures on a card.
SmartPictureFrameNon-Networked.book Page 13 Tuesday, October 9, 2001 4:36 PM