11
Recording Function
1. Choose the “Record” option in the Video Preview Mode. Once selected, the record icon will
appear white.
2. Press the OK/Enter button to enter the prompt interface for switching between Super
8 and 8mm.
3. Use the ilm type switch in front of the ilm scanner to select ilm type. Then, press the
OK/Enter button to record.
NOTE: The ‘Set ilm type’ screen will only appear once per use of the device.
During this process, the device will capture each image of the ilm and combine it into a digital
video. The area in the ilm slot will light up the ilm from the bottom as the ilm is scanned
with the camera above it. The ilm is scanned in the scanning area of the ilm slot frame by
frame. The scanned video is then transferred into your inserted SD™ card.
NOTES: If the ilm has damages or gets stuck, lift the ilm lid and push the damaged area past
the lit-up scanning area. Then, make sure the ilm is irmly in place and reclose the lid.
You can press the OK/Enter button while the recording is in process to stop it. This will
also automatically save the MP4 iles.
Every time you stop and start a recording a new video ile will be created by default.
Frame Adjust Function
1. Press the Up or Down button to choose the “Frame Adjust” option in the Video Preview Mode.
Then, press the OK/Enter button to enter the adjustment interface.
2. After entering the adjustment interface, press the directional arrow buttons to
adjust the margin and press the Plus or Minus button to zoom in or out.
3. Once the desired settings are reached, press the OK/Enter to conirm.
To Next Page
Loading...
