Kodak REELZ - Picture Function Settings

12
NOTE: Film framing may need to be adjusted before starting the recording. This can be
done easily on the device. Move the image around or zoom in or out to properly frame
the ilm. It is important to adjust the camera framing, so the scanner records the
ilm eiciently.
Picture Function
1. Press the Up or Down button to choose the “Picture” option in the Video Preview Mode. Then,
press the OK/Enter button to enter the picture setting interface.
2. After entering the picture setting interface, press the Up or Down button to select the
“Exposure”, “Sharpness”, “Tint”, or “Reset to Default Values” option. Press the Plus or Minus
button to set parameter values.
3. Once the desired settings are reached, press the OK/Enter button to conirm.
NOTE: This function is used to adjust the display of the image. Enhance how the picture of your
ilm looks by choosing the desired settings in this option. Exposure is the overall
brightness or darkness of the ilm. Sharpness refers to the image clarity.
Tint is used to adjust the color of the image. And Reset to Default Values sets
everything back how it was.