Need help?Do you have a question about the Koden KGP-925 and is the answer not in the manual?
General| Dynamics | 6g |
|---|---|
| Channels | 12 |
| SBAS | WAAS, EGNOS, MSAS |
| Acquisition Time (Cold Start) | 45 s |
| Interfaces | NMEA0183 |
| Baud Rate | 4800 bps |
Prevents electric shock during repair by disconnecting unit from ship's main supply.
Warns about static-sensitive devices and electrostatic build-up.
Explains GPS and GLONASS satellite systems' orbits and altitudes.
Meets Russian Federation technical regulations for transport objects.
Tested to IEC 60945 standard and meets marking requirements.
Lists standard items included with the KGP-925.
Technical specifications for the GPS/GLONASS receiver.
Technical specifications for the internal beacon receiver.
Technical specifications for the display unit.
General guidelines for qualified technicians performing installation.
Instructions for table mount and flush mount installation.
Steps for fitting the KGP-925 in flush mounting mode.
Guidance for installing the antenna unit.
Recommendations for antenna placement to ensure optimal signal reception.
Diagrams showing single cable connections to the KGP-925.
Details pin assignments for POWER, DATA, and DATA 2 connectors.
Final checks before powering on the system.
Identifies and explains the functions of the unit's parts and control panel.
Detailed description of each button on the control panel.
Procedure for turning the KGP-925 unit on and off.
How to store current positions as events.
Functionality of the Man Over Board key for emergency situations.
How to store waypoint data using latitude and longitude.
Steps to save or update waypoint positions.
How to set up navigation to a selected waypoint.
Steps for initiating waypoint navigation.
Understanding cross track error and course deviation.
How to store and delete navigation routes.
Steps for saving a new navigation route.
How to configure navigation routes.
How to set and manage anchor positions.
Procedure for saving the current position as an anchor point.
Overview of available alarms: ANCH, PROX, XTE, CDI.
How to set, change range, and cancel alarms.
Overview of the device's menu structure and navigation.
Settings related to GNSS satellite reception.
How to enable the RAIM function for integrity monitoring.
Settings for Differential GNSS (DGNSS) positioning.
Procedures for compensating position and magnetic data.
How to correct the present position data.
How to adjust GPS bearing to magnetic compass bearing.
Settings for initial operational parameters.
Settings for connecting to external systems.
Procedures for initializing the device.
Steps to re-initialize the GPS navigator.
Required initial setup for LOPs mode.
How to compensate GPS position using LOPs.
Guidelines for regular inspection and cleaning.
Procedures for locating and resolving faults.
Table of common faults and remedial actions.
List and explanation of error messages.
Technical details of the digital interface.
How to switch the device to external communication mode.
How to transfer route data to/from external systems.
How to navigate using a transferred route.
To Next Page
