TP-5737 5/01 83Section 8 Disassembly/Reassembly
Section 8 Disassembly/Reassembly
Before beginning the generator set disassembly
procedure, carefully read all safety precautions at the
beginning of this manual. Please observe these
precautions and those included in the text during the
disassembly/ reassembly procedure.
The following procedures cover many models and some
steps may not apply to a particular engine. Use
Figure 8-1 and Figure 8-2 to help understand
component descriptions and general configuration of
the generator set.
Use the disassembly procedure as a step-by-step
means to help take apart the generator set. The
disassembly procedure provides important information
to minimize disassembly time and indicates where
special configurations exist which may require taking
notes. The reassembly procedure includes important
alignment steps and provides critical torque specs.
Accidental starting.
Can cause severe injury or death.
Disconnect the battery cables before
working on the generator set.
Remove the negative (--) lead first
when disconnecting the battery.
Reconnect the negative (--) lead last
when reconnecting the battery.
WARNING
Disabling the generator set. Accidental starting can
cause severe injury or death. Before working on the
generator set or connected equipment, disable the generator
set as follows: (1) Move the generator set master switch to the
OFF position. (2) Disconnect the power to the battery charger.
(3) Remove the battery cables, negative (--) lead first.
Reconnect the negative (--) lead last when reconnecting the
battery. Follow these precautions to prevent starting of the
generator set by an automatic transfer switch, remote
start/stop switch, or engine start command from a remote
computer.
To Next Page
Loading...
