7.5
Section 7
Retractable Starter
7
4. Place the brake washer in the recess in starter
pulley; over the center shaft.
5. Lubricate the brake spring sparingly with
grease. Place the spring on the plain washer.
Make sure the threads in the center shaft remain
clean, dry, and free of grease and oil.
6. Apply a small amount of Loctite
®
No. 271 to the
threads of the center screw. Install the center
screw with the washer and retainer to the
center shaft. Torque the screw to 7.4-8.5 N·m
(65-75 in. lb.).
7. Tension the spring and install the rope and
handle as instructed in steps 6 through 12 under
“Rope Replacement” on page 7.2.
8. Install the starter to the engine blower housing
as instructed in “To Install Starter” on page 7.1.
To Next Page
Loading...
