To Next PageTo Next PageWhy is my Kohler Command CH750 leaking oil from oil seals and gaskets?
If you notice oil leaks from the oil seals and gaskets of your Kohler Engine, the following could be the reasons: * Replace the broken breather reed. * Repair or replace the crankcase breather. * Clear the restricted exhaust. * Tighten fasteners to the correct torque. * Repair or replace the leaky components.
General| Compression Ratio | 8.5:1 |
|---|---|
| Fuel Type | Gasoline |
| Starter Type | Electric |
| Ignition System | Electronic |
| Lubrication | Full Pressure |
| Engine Type | 4-cycle, twin-cylinder, OHV, air-cooled, gasoline engine |
| Displacement | 747 cc (45.6 cu. in.) |
General safety warnings, cautions, and precautions before operating or servicing.
Procedures and schedule for routine engine maintenance.
Key specifications like bore, stroke, displacement, and oil capacity.
Torque values for various fasteners and engine components.
General guide to diagnosing common engine problems.
Common causes and checks for an engine that cranks but won't start.
Causes for an engine that is difficult to start.
Diagnosing problems with the governor system.
Procedures for checking and maintaining the engine oil level.
Specific procedures for testing ignition systems.
Diagnosing common starting problems like no energizing or slow cranking.
Procedures for testing the starter solenoid's pull-in coil and hold-in coil.
