9.2
Section 9
Disassembly
Figure 9-1. Removing Spark Plug Lead, Oil Drains,
Oil Filter, and Oil Sentry
™
Switch (oil fi lter drain
plug not on all models).
Remove Muffl er
1. Remove the hex. fl ange nuts from exhaust studs
and hex. fl ange screws from muffl er bracket. See
Figures 9-2 and 9-3.
2. Remove the muffl er and gasket from exhaust
outlet fl ange. Some engines may have an
additional heat defl ector insert tube in the exhaust
port, behind the muffl er fl ange. If present, remove
it also.
Figure 9-3. Removing Muffl er.
Remove Retractable Starter
1. Remove the fi ve hex. fl ange screws and
retractable starter. See Figure 9-4.
Figure 9-4. Removing Retractable Starter.
Remove Electric Starter
Electric Starter (Bendix Drive or Solenoid Shift)
1. Disconnect the lead from the stud terminal on the
electric starter. See Figure 9-5. Disconnect both
leads on Solenoid Shift Starter.
2. Remove the two hex. fl ange screws and starter
assembly. Some bendix drive starters have
additional spacers between the mounting fl ange
and crankcase or under the head of the mounting
bolt. After noting their placement, remove and
retain the spacers.
Spark Plug
Lead
Oil Drain
Oil Filter
Optional Oil Sentry
™
Switch or
Oil Filter Drain Plug
Hex. Flange
Screws
Muffl er
Muffl er
Gasket
Hex. Flange Nuts
Figure 9-2. Removing Muffl er.
Hex. Flange Screws (5)
Retractable
Starter
Muffl er Bracket
To Next Page
Loading...
Need help?
General