EasyManuals Logo

Kohler Command Pro CV224 User Manual

Kohler Command Pro CV224
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4 14 590 48 Rev. AKohlerEngines.com
Cold Weather Starting Hints
1. Use proper oil for temperature expected.
2. Disengage all possible external loads.
3. Use fresh winter grade fuel. Winter grade
fuel is formulated to improve starting.
Stopping
1. If possible, remove load by disengaging all
PTO driven attachments.
2. If equipped, move throttle control to slow or
idle position; stop engine.
3. If equipped, close fuel shut-o valve.
Angle of Operation
Refer to operating instructions of equipment
this engine powers. Do not operate this engine
exceeding maximum angle of operation; see
speci cation table. Engine damage could result
from insu cient lubrication.
Engine Speed
NOTE: Do not tamper with governor setting to
increase maximum engine speed.
Overspeed is hazardous and will void
warranty.
High Altitude Operation
If this engine is operated at an altitude of
4000 ft. (1219 meters) or above, a high altitude
carburetor kit is required. To obtain high altitude
carburetor kit information or to nd a Kohler
authorized dealer, visit KohlerEngines.com or
call 1-800-544-2444 (U.S. and Canada).
This engine should be operated in its original
con guration below 4000 ft. (1219 meters).
Operating this engine with the wrong engine
con guration at a given altitude may increase
its emissions, decrease fuel e ciency and
performance, and result in damage to the
engine.
Starting
WARNING
Carbon Monoxide can cause
severe nausea, fainting or death.
Avoid inhaling exhaust fumes.
Never run engine indoors or in
enclosed spaces.
Engine exhaust gases contain poisonous
carbon monoxide. Carbon monoxide is
odorless, colorless, and can cause death if
inhaled.
WARNING
Rotating Parts can cause severe
injury.
Stay away while engine is in
operation.
Keep hands, feet, hair, and clothing away
from all moving parts to prevent injury. Never
operate engine with covers, shrouds, or
guards removed.
NOTE: Choke position for starting may vary
depending upon temperature and other
factors. Once engine is running and
warm, turn choke to OFF position.
NOTE: Extend starter cord periodically to
check its condition. If cord is frayed
have it replaced immediately by a
Kohler authorized dealer.
1. Turn fuel shut-o valve to ON position
(if equipped).
2. Turn engine on/o switch to ON position
(if equipped).
3. Start engine as follows:
Cold engine: Place throttle control to FAST
position. Pull choke control into CHOKE/ON
position.
Warm engine: Place throttle control to RUN/
FAST position.
4. Slowly pull starter handle until just past
compression-STOP! Return starter handle;
rmly pull straight out to avoid excessive
rope wear from starter rope guide.
5. Gradually return choke control to OFF
position after engine starts and warms up.
Engine/equipment may be operated during
warm up period, but it may be necessary to
leave choke partially on until engine warms
up.

Other manuals for Kohler Command Pro CV224

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kohler Command Pro CV224 and is the answer not in the manual?

Kohler Command Pro CV224 Specifications

General IconGeneral
BrandKohler
ModelCommand Pro CV224
CategoryEngine
LanguageEnglish

Related product manuals