Kohler Command PRO ECH749 Service Manual

2.2
Section 2
Tools & Aids
Tools (Continued)
Description Source/Part No.
Hydraulic Valve Li er Tool
To remove and install hydraulic li ers.
Kohler 25 761 38-S
Ignition System Tester
For testing output on all systems, including CD.
Kohler 25 455 01-S
Off set Wrench (K & M Series)
To remove and reinstall cylinder barrel retaining nuts.
Kohler 52 455 04-S
Oil Pressure Test Kit
To test and verify oil pressure.
Kohler 25 761 06-S
Rectifi er-Regulator Tester (120 volt current)
Rectifi er-Regulator Tester (240 volt current)
Used to test rectifi er-regulators.
Kohler 25 761 20-S
Kohler 25 761 41-S
Individual Components Available
CS-PRO Regulator Test Harness
Special Regulator Test Harness with Diode
Design Technology Inc.
DTI-031
DTI-033
Spark Advance Module (SAM) Tester
To test the SAM (ASAM and DSAM) on engines with SMART-SPARK™.
Kohler 25 761 40-S
Starter Servicing Kit (All Starters)
To remove and reinstall drive retaining rings and brushes.
SE Tools KLR-82411
Individual Component Available
Starter Brush Holding Tool (Solenoid Shi )
SE Tools KLR-82416
Tachometer (Digital Inductive)
For checking operating speed (RPM) of an engine.
Design Technology Inc.
DTI-110
Vacuum/Pressure Tester
Alternative to a water manometer.
Kohler 25 761 22-S

Kohler Command PRO ECH749 Specifications

General

Fuel System	Carburetor
Starter	Electric
Governor Type	Mechanical
Lubrication System	Full Pressure
Fuel Type	Gasoline
Crankshaft Orientation	Horizontal
Bore	3.27 in (83 mm)
Cooling System	Air
Oil Type	SAE 10W-30
Spark Plug Gap	0.030 in (0.76 mm)
Valve Clearance - Intake	0.004 - 0.006 in (0.10 - 0.15 mm)
Crankshaft Type	Varies by model
Crankshaft Thread Size	Varies by model
Crankshaft Length	Varies by model
Crankshaft Diameter	Varies by model
Type	Overhead Valve (OHV)