B
- Front Wash…night light setting
Low voltage alarm
Note: please replace battery in time when the voltage alarm starts.
Pairing
Communication between remote control and toilet
When cover and seat is powered on, long press dryer button, when all lights quick blinks twice, dryer light blinks
slowly. Long press Front and Rear Wash buttons both on side panel simultaneously in 20s, release button until
one short beep is generated. When light strip stops blinking indicates pairing is successful.
When remote moves away from sensing zone, press any button, all light strip will blinks slowly, starts searching
connection. After successful connection, it will stop blinking.
Remote controller setting guide
Long press this button to start night light setting mode, Front Wash icon blinks slowly; press Front Wash icon
to change setting per activation or deactivation circulation.
1. When Front Wash indicating LED lights up, indicates night light starts. Toilet generates one short beep.
2. When Front Wash indicating LED lights OFF, indicates night light stops. Toilet generates one long beep.
When M battery alarm icon blinks indicate remote battery is almost used up. Replace battery is required.
key until a short pip is heard, and release the key only after the night lamp flickers for three
Note: Normal function will not be used when initiate any long press setting.
Keep pressing the
times. Then change the setting of B/D/G/I/J/K/L by the following requirements.
I J K L M
A B C D E F G H
D - Massage…prolonged seating indication setting
G - Ring temp … energy saving setting
1. When massage indicating LED lights up, indicates prolonged seating indication function starts. Toilet generates one short beep.
2. When massage indicating LED lights OFF, indicates prolonged seating indication function stops. Toilet generates one long beep.
Long press this button to start energy saving setting, seat temp icon blinks slowly. Press seat temp icon again
to change per starts and stops circulation.
1. When Seat Temp indicating LED lights up, indicates energy saving function starts. Toilet generates one short beep.
2. When seat temp indicating LED lights OFF, indicates energy saving function stops. Toilet generates one long beep.
Press and hold this button to enter prolonged seating indication setting, massage icon starts blinking slowly.
Press massage icon for different setting per activate or deactivate circulation.
To Next Page
Loading...
Need help?
General