Kohler K-1151 - User Manual

Other manuals for Kohler K-1151

Questions and Answers

M
Marissa CarrAug 11, 2025
What to do if my Kohler Kitchen & Bath Fixtures whirlpool stops automatically?
- A
  Alexander TurnerAug 11, 2025
  If your Kohler Kitchen & Bath Fixtures whirlpool stops automatically, it may be due to several reasons. The GFCI might be tripping, in which case you should identify and correct the source of the fault. A blocked suction requires removing the obstruction. Blocked jets also need the obstruction removed. If the motor overheated, check for blockages at the motor vents, suction, or jets; remove any blockages and allow the motor to cool.
A
andersonelizabethAug 16, 2025
How to fix a Kohler Kitchen & Bath Fixtures whirlpool that does not start or stop?
- L
  Louis SotoAug 16, 2025
  If your Kohler Kitchen & Bath Fixtures whirlpool isn't starting or stopping, there could be a few reasons. First, ensure there is power to the motor by setting/resetting the GFCI breaker and checking the wiring. If the air actuator isn't working, consider replacing it and check the air tube between the air actuator and the pump. Finally, if the motor/pump isn't functioning, you might need to rebuild or replace it.
T
Tyler DavenportAug 22, 2025
Why is my Kohler Kitchen & Bath Fixtures heater not working?
- J
  Jeffery Costa MDAug 23, 2025
  If the heater in your Kohler Kitchen & Bath Fixtures isn't operating, there are a few potential causes. First, check that there is power to the heater by resetting the GFCI. If the water temperature exceeds 104°F (40°C), allow the water to cool, and the heater will re-engage. If neither of these is the issue, the heater itself may need to be replaced.
D
Dr. Matthew Andersen DVMAug 29, 2025
What to do if motor starts, but all jets are not functioning in my Kohler Kitchen & Bath Fixtures?
- J
  Jennifer TurnerAug 29, 2025
  If the motor in your Kohler Kitchen & Bath Fixtures is running but the jets aren't working, it could be due to a couple of issues. First, check if the jet is closed, and if so, rotate the jet trim ring counterclockwise to open it. Alternatively, the jets might be blocked, in which case you should remove the blockage.
T
thompsonthomasSep 4, 2025
How to reduce noisy operation in Kohler Kitchen & Bath Fixtures?
- M
  Michael PorterSep 4, 2025
  If your Kohler Kitchen & Bath Fixtures is operating noisily, it might be because the pump banding straps haven't been cut. Cut the pump banding straps with tin snips.

Kohler K-1151 Specifications

General

Type	Alcove
Material	Cast Iron
Length	60 inches
Width	32 inches
Drain Location	Right
Shape	Rectangular
Product Type	Bathtub
Model Number	K-1151
Color	White
Installation	Alcove
Exterior Width	32 inches