2. Install the Faucet
Fit the faucet through the sink hole.
Position the faucet so the handle faces toward the user.
Partially thread two screws into the threaded ring until they
barely protrude from the backside of the threaded ring.
Slide the fiber washer, metal washer, and ring to the threaded
shank until it is about 1/4″ (6 mm) from touching the sink
bottom.
Turn the ring so the screws are to the front and back of the
faucet.
Tighten the screws securely and evenly using a Phillips
screwdriver.
Metal Washer
Ring
Screw
Sink
Threaded Shank
Fiber Washer
Kohler Co. 5 1004614-2-E
To Next Page
Loading...
