Remote Control Setup
NOTE: A remote control must be paired with the toilet seat before use. The included remote control should already be
paired with your seat. If a replacement remote control is required, follow the instructions below to pair with your seat.
NOTE: Only one remote control can be paired with the toilet seat at a time.
NOTE: The remote control cannot be paired while the toilet seat is occupied.
Verify that four AA baeries are installed correctly in the remote control. Refer to the “Replacing the Baeries” section.
Move the new remote control near the toilet seat.
Verify that all other remote controls have been removed from the seat area.
Press and hold the “Dryer” icon on the remote control until all the icons blink twice.
Simultaneously press and hold the “Front” and “Rear” icons on the toilet control panel until a beep is heard.
When the icons on the remote control stop blinking, the remote control has been paired.
Kohler Co. 7
1486085-5-C
To Next Page
Loading...
Need help?
General
