Kohler K-4709 - Cleansing Features Troubleshooting

Troubleshooting (cont.)
General Features
Symptoms Probable Causes Recommended Action
C. The LED power
indicator is off.
C. Press the ″Power″
icon.
2. Power light is
not on.
A. Power cord may be
loose or
disconnected.
A. Check the power
cord connection.
B. The Ground-Fault
Circuit-Interrupter
(GFCI) or Residual
Current Device
(RCD) is tripped.
B. Reset the GFCI or
RCD.
C. The circuit breaker
has been tripped.
C. Reset the circuit
breaker.
D. None of the above
actions correct the
symptom.
D. Contact a Kohler
Service
Representative.
3. The seat is
loose.
A. The mounting
plate fasteners are
loose.
A. Tighten the fasteners.
Refer to the
Installation Guide.
Cleansing Features
Symptoms Probable Causes Recommended Action
1. There is no
water flow.
A. The water supply
stop is closed.
A. Open the water
supply stop.
B. The seat sensor is
not detecting the
user.
B. See activating the
seat information in
the ″Operation″
section.
2. The water
pressure is low.
A. The filter screen is
clogged.
A. Clean or replace the
filter screen. See the
″Cleaning the Filter
Screen″ section.
3. Water stops
flowing from
the spray wand
before
cleansing is
complete.
A. Washing
automatically stops
one minute after
pressing a spray
icon.
A. Press the ″FRONT″
or ″REAR″ icon to
restart cleansing.
B. The seat sensor
does not detect the
user.
B. See activating the
seat information in
the ″Operation″
section.
1054180-5-H 12 Kohler Co.