3. Complete the Faucet Installation
Thread the two screws into the threaded ring until they barely
protrude from the top of the threaded ring.
Install the rubber gasket to the underside of the spout.
Fit the spout through the sink hole.
Position the spout so that it faces forward. The Kohler logo
should be facing the user.
Fit the fiber washer and metal washer on the spout shank.
Install the threaded ring to the spout shank until the threaded
ring is just touching the sink.
Turn the threaded ring so that the screws are to the front and
back of the spout.
Position the spout to obtain the desired range of rotation.
Securely tighten the screws.
Spout
Sink
Screw
Threaded
Ring
Fiber Washer
Rubber Gasket
Spout Shank
Kohler Logo
Metal Washer
1025493-2-B 4 Kohler Co.
To Next Page
Loading...
