Need help?Do you have a question about the Kohler K-6284 and is the answer not in the manual?
General| Brand | Kohler |
|---|---|
| Model | K-6284 |
| Category | Plumbing Product |
| Language | English |
Details framing requirements and installation advice for freezing temperatures.
Specifies compatible bowls and essential pre-installation checks for proper function.
Warns about electrical safety for bidet seat installations, requiring GFCI/RCD protection.
Specifies critical framing dimensions, including stud spacing and outlet pipe center alignment.
Advises on potential relocation of the waste outlet pipe.
Discusses PVC vs. cast iron elbows and potential drain pipe height adjustments.
Instructions for temporarily raising the carriage to facilitate leg adjustments and bolt access.
Details the installation of the electrical box for bidet seat compatibility.
Ensures the carriage is positioned upright and stable.
Steps for releasing the support strap, aligning the elbow/waste pipe, and securing the connection.
Guides on positioning, aligning, checking plumb, and marking for carriage mounting.
Details on securing carriage feet with lag bolts and installing threaded rods.
Explains the importance, range, and measurement process for adjusting carriage height.
Steps for lowering the carriage and ensuring elbow alignment with the drain pipe.
Instructions for installing support braces and securing the carriage top to studs.
Details on drilling the inlet hole and connecting power for bidet seats.
General guidelines for installing water supply pipes and waste pipes according to local codes.
Specifics for installing bidet water supply, including shut-off valve placement and dimensions.
Instructions for inserting plaster guards into the inlet and outlet holes of the carriage.
Details on installing the flush shield and flat panel in the flush valve opening.
Guidance on installing cement board with specific dimensions and hole placement behind the bowl.
Instruction to install the final finished wall layer.
Procedure for trimming the flush shield to be flush with the finished wall surface.
Instructions for manipulating the locking tabs on the faceplate.
Steps for aligning and installing the lift rod assembly and securing the faceplate.
Warning against using in-tank cleaners due to potential damage from chlorine compounds.
Provides guidelines for safe and effective cleaning of the product surfaces.
Specific cleaning advice for Artist Edition toilets, emphasizing gentle methods.
Addresses issues with poor flushing due to low water levels and suggests corrective actions.
Diagnoses running fill valve issues caused by excessive water levels and provides adjustment steps.
Covers leaks originating from behind the bowl, focusing on gasket placement and lubrication.
Addresses flex in the carriage and bowl due to insufficient frame support, recommending additional bracing.
Troubleshoots lack of water flow, checking for closed supply stops and obstructions.
Details the one-year limited warranty, covering defects in material and workmanship.
Explains how to obtain warranty service and outlines limitations on implied warranties and consequential damages.
To Next Page
