4. Position Channel
NOTE: Metal and plastic components may have sharp edges and
corners. Handle these parts carefully.
Fit the channel over the spout shank with the open end facing the
valve.
Insert two square-head bolts through the top holes in the channel.
Install the washers and hex nuts over the two square-head bolts.
Position the top of the channel so that it is even with the bottom
of the spout shank threads.
Securely tighten the hex nuts with a wrench.
Channel
Washer
Spout Shank
Hex Nut
Square-Head Bolt
Kohler Co. 5 1025493-2-B
To Next Page
Loading...
