Kohler K-7397 - Install the Showerhead

2. Install the Showerhead
Remove the temporary nipple from the shower ell.
Apply a bead of plumbers putty or other sealant to the back of
the flange according to the manufacturer’s instructions.
Slide the wall flange onto the shower arm.
Apply thread sealant tape to the threads and install the shower
arm to the shower ell.
Carefully tighten with a clean strap wrench.
Press the flange against the finished wall and secure to the
shower arm by tightening the setscrew.
Remove all excess putty.
With the showerhead off, flush out the system.
Apply thread sealant tape to the shower arm and thread the
showerhead to the shower arm.
Use a clean strap wrench to tighten the showerhead.
Check for proper operation.
Shower Ell
Wall Flange
Shower
Arm
Apply plumbers
putty.
Showerhead
Setscrew
113291-2-AB 4 Kohler Co.