3. Prepare the Site
IMPORTANT! Allow for a 1/4″ (6 mm) overlap for the lip of the
speaker support and a minimum clearance of 1/2″ (1.3 cm) around
the back of the opening to enable the clamp arms to fully engage.
Refer to the rough-in information. With a pencil, mark the cut
lines onto the finished wall.
Carefully cut out the opening in the finished wall following the
penciled guidelines.
For thin finished wall materials of less than 3/16″ (5 mm), shim
around the back of the opening to provide adequate support for
mounting the speaker support.
1/4" (6 mm)
Cutout
Wall
Shim
Clamp Arm
Shim behind thin
walls if necessary.
Wall Support
Overlap
Cutout Detail
4-5/16" – 4-7/16"
(11 – 11.3 cm)
4-5/16" – 4-7/16"
(11 – 11.3 cm)
3/16" (5 mm) Min –
2" (5.1 cm) Max Depth
1070937-2-A 6 Kohler Co.
To Next Page
Loading...
Need help?
General